b881: Config, Modules, WDM Audio: problem and Range Check error

Archive mAirList 3.x (English)
1

In Config, opening the Modules, WDM audio node shows Sample rate as zero.

Whether one changes this to the ‘usual’ 44100, or leaves it at the displayed value of zero, clicking another node or clicking Save causes a Range check error.

This does not seem to cause any errors, and mAirList plays files correctly and without any audio problems.

If it helps, in my bass.ini [Device 1] section, there is the expected key of Samplerate=44100, and this is for the only sound card on this PC, which is a Realtek built in to the HP motherboard.

Bug report attached.

PS: I assume (maybe incorrectly) that this field SHOULD show a sample rate of 44100 (or 48000, depending on the sound card): I think it USED to show 44100 on this PC. Is that correct?

BFN
CAD

bugreport.txt (54.4 KB)

2

It’s a bug in one of the 3.1.4 snapshots. The BASS WDM config settings were a bit messed up. Build 883 is ok again, but you need to review your settings if you used any of the faulty snapshots.